topic RE: Question about how to set conditions for break point and while process published in Product Forum

Question about how to set conditions for break point and while process published

PankajNaik — Sun, 05 Jul 2020 05:37:00 GMT

Hi,

1) How to set break point condition

2) While publishing Process , what is pre and post conditions and moreover how can we set that . And what is the use of these conditions ?

------------------------------
Pankaj Naik
------------------------------

RE: Question about how to set conditions for break point and while process published

John__Carter — Mon, 06 Jul 2020 07:46:00 GMT

1) Set a Break Point first, then right click again and select Break Point Condition. In the expression editor, create an expression such as [My Value]=10 to define the condition. See the Help for more explanation of how the condition will be met.

2) Pre and post conditions are unrelated to break points. They are for documenting a design principle where you state 'what must be true before this page starts' and 'what will be true after this page ends'.

------------------------------
John Carter
Professional Services
Blue Prism
------------------------------

RE: Question about how to set conditions for break point and while process published

PankajNaik — Mon, 06 Jul 2020 16:59:00 GMT

Hello,

Thank you very much sir.

What is Pre condition and post condition and how to set these condition. When we click on Information process stage , we will see these pre and post condition.

Please tell about this and what is the use of and how and where we will use.

Regards,

Pankaj