Hi folks!
We are migrating from BP6.5 to BP6.10.5. When I open any process or object in Studio for BP6.10.5, the texts in the stages are too small to read. My default Zoom is at 75%. If I increase to 100%, then it is all good readable, but the stages are larger than I'd like them to be.
In BP6.5 I had the
same font,
same font size, and same stages size and everything was very good readable with the
same 75% zoom. I would on occasion use 100% to display longer texts but usually 75% would do just fine. In BP6.10 this is clearly no longer the case, the stages are still ok, the font size is not and definitely too small. My 75% zoom used to provide me with a good overview over the page logic, combined with readable stage texts.
Of course I can set each page to 100% but this will enlarge the stages to a point where you have to browse too much and loose the overview. The zoom for 75% has not changed for the stages in BP6.10, only the font size seems to have changed.
Note that I run both BP versions on the same computer, so the system settings are exactly the same for both versions of BP.
Simple questions (...famous last words...):
- How do I get back to the combination 75% zoom and readable stage texts in BP6.10?
- Are there any BP system settings that I can tinker with to fix this?
- If both not possible: How can I set a new font size for a all stages in a process or object?
Happy coding!
---------------
Paul
Sweden
Happy coding!
Paul, Sweden
(By all means, do not mark this as the best answer!)
