09-06-21 03:10 AM
Hi Team
I'm unable to load any saved branch into the process flow in Capture 2.1. PFA video for reference
I have tried this activity across different process as well but still I'm encountering the same response.
Could you please check and let me know if there is any bug in the current version 2.1?
Steps Followed:
1. Created Decision points
2. Load Saved Branch
3. Page loads but i don't see any output (i.e. saved branch doesn't loaded up in the existing process flow)
Note: I was able to perform this activity in the previous version 2.0
21-06-21 02:11 PM
29-06-21 09:17 AM
Have you tried a fresh install of Capture?
>> Yes i did the fresh installation.
Is this issue limited to a particular branch that you are trying to load, or does this occur on every use of "Load saved branch" ?
>>This occurs to all the branch that I'm trying to load
Are you able to open the process "Test1cap" successfully?
Yes
As per the suggestion I have tried creating a new Empty branch and tried to load the saved branch but facing the same issues again.
Could you please let me know any resolution for this ?
29-06-21 12:23 PM